Cisco Systems SM-ISM, SA-ISA manual Preparing for Installation, Required Tools and Equipment

C H A P T E R 2

Preparing for Installation

This chapter describes the general equipment, safety, and site preparation requirements for installing the ISA and the ISM.

This chapter contains the following sections:

•Required Tools and Equipment, page 2-1

•Software and Hardware Requirements and Compatibility, page 2-1

•Software Compatibility, page 2-2

•Safety Guidelines, page 2-3

•Compliance with U.S. Export Laws and Regulations Regarding Encryption, page 2-6

Required Tools and Equipment

You need the following tools and parts to install an ISA or ISM. If you need additional equipment, contact a service representative for ordering information.

•SA-ISA(=) service adapter or SM-ISM(=) service module

•Number 2 Phillips screwdriver

•Your own electrostatic discharge (ESD)-prevention equipment or the disposable grounding wrist strap included with all upgrade kits, field-replaceable units (FRUs), and spares

•Antistatic mat

•Antistatic container

Software and Hardware Requirements and Compatibility

Table 2-1lists the recommended minimum Cisco IOS software release required to use the ISA/ISM in supported router or switch platforms.

Note The Cisco 7100 series VPN routers do not support an ISM and an ISA in the same chassis. The Cisco 7200 series routers do not support the ISM.

The ISA and the ISM are the same board, but differ in their outside appearance.

Integrated Services Adapter and Integrated Services Module Installation and Configuration

OL-3575-01 B0 2-1