Command Reference
show interface cable-modem
To display information about the cable modem interface on a cable modem, use the show interface
show interface
Syntax Description
number | Cable modem interface number. |
accounting | (Optional) Displays the number of packets of each protocol type |
| that has been sent through the cable modem interface. |
counters | (Optional) Shows MIB counters on the cable interface. |
crb | (Optional) Displays routing and bridging information pertaining |
| to the cable interface. |
irb | (Optional) Displays routing and bridging information pertaining |
| to the cable interface. |
Command Mode
EXEC
Usage Guidelines
This command first appeared in Cisco IOS Release 11.3 NA.
Sample Display
Traffic passing through the cable modem interface is shown in the following example:
uBR904# show interface
Hardware is BCM3220, address is 0010.7b43.aa01 (bia 0010.7b43.aa01) Internet address is 188.188.1.60/16
MTU 1500 bytes, BW 27000 Kbit, DLY 1000 usec, rely 255/255, load 1/255 Encapsulation , loopback not set, keepalive not set
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:07:04, output 00:00:41, output hang never Last clearing of "show interface" counters never Queueing strategy: fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops 5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
4495 packets input, 1153221 bytes, 0 no buffer Received 8 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort 12841 packets output, 1708272 bytes, 0 underruns
0 output errors, 0 collisions, 11 interface resets
0 output buffer failures, 0 output buffers swapped out
40Release 11.3(4)NA
