Installing the 24-Port FXS Analog Interface Module

Required Tools

These tools are required to install the 24-port FXS analog module in the Catalyst 6500 series switches:

Number 1 and number 2 Phillips screwdrivers for the captive installation screws

Antistatic mat or antistatic foam

Wrist strap or other grounding device

Removing Modules

Caution During this procedure, wear grounding wrist straps to avoid ESD damage to the module. Do not directly touch the backplane with your hand or any metal tool, or you could shock yourself.

Caution To prevent ESD damage, handle modules by the carrier edges only.

To remove a module from a Catalyst 6500 Series Switch, perform these steps:

Step 1 Disconnect any network interface cables attached to the ports on the module you intend to remove. Step 2 Loosen the captive installation screws, as shown in Figure 3.

Figure 3 Ejector Levers and Captive Installation Screws

WS-X6624-FXS

STATUS

1

4

7

10

13

16

19

22

2

5

8

11

14

17

20

23

 

3

6

9

12

15

18

21

24

-1 24

24 PORT FXS ANALOG STATION

Ejector lever Captive installation screws

38859

Step 3 Grasp the left and right ejector levers and simultaneously pivot the levers outward to release the module from the backplane connector. Figure 3 shows a close-up of the right ejector lever.

Step 4 Grasp the module front panel with one hand and place your other hand under the carrier to support and guide it out of the slot. Do not touch the printed circuit boards or connector pins.

Step 5 Carefully pull the module straight out of the slot, keeping your other hand under the carrier to guide it. Step 6 Place the module on an antistatic mat or antistatic foam, or immediately install it in another slot.

Catalyst 6500 Series 24-Port FXS Analog Interface Module Installation Note

12

78-10975-02

 

 

Page 12
Image 12
Cisco Systems WS-X6624-FXS specifications Required Tools, Removing Modules