CBM1000 Service Manual
3.Removing the Top Cover SA
(1)Remove the printer cover SA.
(2)Remove the two screws M3 × 6 (ST). While unhooking the part “B” of the frame from the top cover SA, lift the top cover. At this time, avoid the power switch.
(3)Unhook the operation panel cable from the cable holder, disconnect the opera- tion panel connector from the control PCB assy, and remove the top cover SA.
Note on reassembling:
When reassembling the top cover SA, be sure that the part “B” of the frame is securely inserted into the square hole at the back of the top cover SA as shown in the figure.
4.Removing the Mechanism Unit
(1)Remove the top cover SA.
(2)Remove the two screws M3 × 6 (ST).
(3)Disconnect the five connectors “A to E” from the control PCB assy.
(4)Lift the front part of the mechanism unit a little and remove the mechanism unit by disengaging it from two square holes on the bottom chassis.
B Square Hole
Top Cover SA
M3×6 (ST)
Operation Panel
Connector
Power Switch | Cable Holder |
|
Mechanism Unit | M3×6 (ST) |
|
Bottom Chassis
Square Hole
– 9 – | CITIZEN |
