1.Lift the cover open button.
2.Open the printer cover.
3.Insert a paper roll with its print area facing down as shown in the figure and pull out the paper end straightforward by several cm out of the printer.
4.Firmly close the printer cover until a click can be heard. With the factory setting, the paper is fed and cut automatically.
See 5.3 Manual Setting of Memory Switch
CAUTION!
■Always use the specified types of paper roll.
■Confirm that the paper roll is set correctly.
■When the paper is skewed and not extended straightforward from under the printer cover, open the printer cover and adjust the paper correctly.
■When the cover is opened after paper setting, be sure to pull the paper straightforward by several cm out of the printer, and then close the cover.
■When closing the printer cover, press on the center part of the cover to close it firmly.
■When setting paper, be careful not to have your finger injured by the paper edge.
WARNING
When opening the printer cover, DO NOT touch the print head or cutter blade. Otherwise, burning or injury of hand may result.
— 17 —