Paper type selection is available by the combination of memory switches
1 Enter Selecting Paper Type mode.
1)Open the printer cover and remove paper. Pressing and holding the FEED button, turn the printer power ON. The POWER LED starts blinking.
2)Release the FEED button and then close the printer cover. Buzzer sounds and the paper type currently set is indicated by the LED on the operation panel.
2Select Paper Type.
Press the FEED button to match the paper type loaded to the LED indications in the table below. (Refer to the table below.)
|
|
| POWER LED | ERROR LED |
|
|
| ||
|
|
|
|
|
| Label | Green lit | (OFF) | |
|
|
|
| |
|
|
|
|
|
| Thermal paper roll | (OFF) | Red lit | |
|
|
|
| |
|
|
|
|
|
| Black mark paper | Green lit | Red lit | |
|
|
|
|
|
|
|
|
|
|
3Save the selected Paper Type to the Printer.
Open and close the printer cover. By this operation, selected paper type is stored in the printer memory and the Selecting Paper Type mode is terminated.
Since then, "P.Length Set" of Memory switch
When closing the printer cover during the setting a black mark paper or label paper in the printer, paper length is measured, and the result will be printed out.
*When paper detection error occurs at the measurement of paper length, automatically enters paper sensor adjustment mode. Adjust the sensor in accordance with “5.5 Adjusting the Sensitivity of Paper Sensor”.
5.5 Adjusting the Sensitivity of Paper Sensor*LBefore using black mark paper (BM paper) or label paper, adjust the sensitivity of the paper sensor by using actual paper.
1Enter Adjusting Paper Sensor mode.
Open the printer cover, remove paper, and then set the printer power switch to ON. Here, POWER LED and ERROR LED go on with the buzzer sound. Then close the printer cover while pressing the FEED button. The ERROR LED starts blinking with the buzzer sound.
— 26 —