Citizen CT-S2000, CT-S2000DC, CT-S2000DCL, CT-S2000L 5.3 Manual Setting of Memory Switch

5.3 Manual Setting of Memory Switch

Memory switches can be set manually or by a command.

For manual setting, refer to the next page.

The function of each memory switch is shown in the following table. (The white-on-black characters are factory setting.)

Switch No.	Setting				0 (OFF)		1 (ON)
Memory SW1-1	Power ON Info				Valid		Not send
SW1-2	Buffer Size		4k bytes				45 bytes
SW1-3	Busy Condition			Full/Err					Full
SW1-4	Receive Error			Print ?			No Print
SW1-5	CR mode			Ignored					LF
SW1-6	Reserved				Fixed				−
SW1-7	DSR Signal			Invalid					Valid
SW1-8	Init Signal			Invalid					Valid
Memory SW2-1	Reserved				−			Fixed
SW2-2	Auto Cutter			Invalid					Valid
SW2-3	Spool Print			Invalid					Valid
SW2-4	Full Col Print		LineFeed				WaitData
SW2-5	Resume aft PE				Next				Top
SW2-6	Reserved				Fixed				−
SW2-7	Reserved				Fixed				−
SW2-8	PNE Sensor				Valid		Invalid			**
Memory SW3-1	Resum Cttr Err						Invalid
					Valid
SW3-2	Reserved
					Fixed				−
SW3-3	Parallel 31 Pin				Valid		Invalid
SW3-4	Reserved				Fixed				−
SW3-5	Reserved				Fixed				−
SW3-6	Reserved				Fixed				−
SW3-7	CBM1000 Mode			Invalid					Valid
SW3-8	Resum Open Err				Close	Command
Memory SW4-1	Reserved				Fixed				−
SW4-1*L	Paper Length Setting	Auto Measure				Command
SW4-2	Reserved				Fixed				−
SW4-2*L	Top of Form at Power ON			Invalid					Valid
SW4-3	Feed&Cut at TOF			Invalid					Valid
SW4-4	Reserved				Fixed				−
SW4-4*L	Paper Select	Thermal Roll				BM.P/Lbl.P					*
SW4-5	Reserved				Fixed				−
SW4-5*L	Position Detect	Black Mark						Label
SW4-6	Reserved				Fixed				−
SW4-6*L	Paper Change			Invalid					Valid
SW4-7	Reserved				Fixed				−
SW4-8	Partial only			Invalid					Valid

*When printing on label paper, adjust the layout so that right and left margins are 4 mm or more.

*The memory switch SW4-8 will be ignored for black mark paper.

*The memory switches SW2-8 and SW4-8 will be ignored for label.

— 23 —