3.5 Partition for Paper Roll
At the time of shipment, this partition is not installed.
1.Confirm that the power switch is OFF.
2.Open the printer cover.
3.Insert the partition into the slot and align it with the scale inside of the printer which meets the width of the paper roll used. When using the 80mm or 82.5mm wide paper roll, set the partition by using the accessory screw.
4.Change the setting of paper width by reffering to the section 5.2, "Manual Setting of Memory Switch".
CAUTION!
When using 112 paper roll, the partition is not used.
3.6 Setting DIP Switch
Partition→ |
Scales→ |
80mm 82.5mm |
Partition
The DIP switch is present on the serial interface board.
The function of each switch is as shown below.
Interface board | DIP switch |
| |
mounting screws |
|
CAUTION!
■As for the setting of the serial interface, it gives priority to the setting of the memory switch rather than the DIP switch as the factory default.
■Consult with the dealer where the printer was purchased when the change of the DIP switch setting is necessary.
Switch No. | Function | ON |
| OFF | InitialSettings | |
1 | Communication condition | DIP switch setting | Memory switch | OFF | ||
| setting method |
|
| setting |
| |
2 | Hand shake | XON/XOFF | DTR/DSR | OFF | ||
3 | Bit length | 7 bits | 8 bits | OFF | ||
4 | Parity check | With parity | None | OFF | ||
5 | Parity selection | Even parity | Odd parity | OFF | ||
6 |
|
|
|
|
| OFF |
Baud rate selection | See Table below. |
|
|
| ||
7 |
|
|
| ON | ||
|
|
|
|
| ||
|
|
|
|
| ||
8 | INIT | Reset | Invalid | OFF | ||
Selecting baud rate
Baud Rate (bps) |
| Switch No. | |
6 |
| 7 | |
|
| ||
2400 | OFF |
| OFF |
4800 | ON |
| OFF |
9600 | OFF |
| ON |
19200 | ON |
| ON |
38400, 57600 and 115200 bps can also be selected by a command, etc.
— 15 —
