PRECAUTIONS IN HANDLING THE PRINTER
WARNING
Please observe the following precautions for power source and power cord:
■Do not plug or unplug the power cord with a wet hand.
■Use the printer only at the specified supply voltage and frequency.
■Check to make sure that the supply outlet from which the printer is powered has a sufficient capacity.
■Do not supply the printer from a power strip or current tap shared with other appliances.
■Do not plug the power cord into a supply outlet with dust or debris
left on its plug.
■ Do not use a deformed or damaged power cord.
■Do not move the printer while the printer power is on.
• Neglecting to handle properly may result in printer failure, emission of smoke, fire, or electric shock.
• An overload may cause the power cord to overheat or fire or the circuit breaker to trip.
■Do not allow anything to rest on the power cord. Do not place the
printer where the power cord will be trampled on.
■Do not use or carry the printer with its power cord bent, twisted, or
pulled.
■Do not attempt to modify the power cord unnecessarily.
■ Do not lay the power cord in the neighbor of a heating device.
•Neglecting these cautions may cause wires or insulation to break, which could result in leakage, electric shock, or printer failure. If the
power cord sustains damage, contact your Citizen Systems dealer.
■Do not leave things around the supply outlet.
■Supply power to the printer from a convenient wall outlet, readily
accessible in an emergency.
•The printer may not be immediately shut down in an emergency. ■ Insert the power plug fully into the outlet.
■ If the printer will not be used for a long time, leave it disconnected
from its supply outlet.
■ Hold the plug and connector when plugging or unplugging the power cord or signal cable after turning off the printer and the appliance connected to it.
— 5 —
