Clarion CMD5 Turning on/off the power, Selecting a mode, Adjusting the volume, Adjusting the bass

Basic Operations

Note:

•Be sure to read this chapter referring to the front diagrams of chapter "3. CONTROLS" on page 6.

Lower the volume level before powering the source unit off. The source unit stores the last volume setting. If the source unit is powered off with the volume up, when the source unit is powered back on, the sudden loud volume may harm your hearing and/or damage the source unit.

A WARNING

When the front panel is open, no sound is produced, and source unit controls and remote control unit operations are disabled. Always shut the front panel after changing the CD.

EXPOSING THE UNITTO WATER WITH THE FRONT PANEL OPEN WILL CAUSE DAMAGE OR UNIT MALFUNCTIONl

Turning on/off the power

1.Press the [POWER] button.

2.The illumination and display on the unit light up. The unit automatically remembers its last operation mode and will automatically switch to display that mode.

3.Press the [POWER] button to turn off the power for the unit.

Note:

•System check

During the initial power up of this unit, it will go through a system check procedure. This procedure verifies any devices connected through GeNET. Any additional GeNET devices plugged into the unit after the initial power up will initiate the system check procedure. The system check starts automatically within the unit.

Selecting a mode

Press the [DISC], [SAT], [AM/FM] or [AUX] button to change the operation mode.

*External equipment not connected with CeNET is not displayed.

Adjusting the volume

Turning the [VOLUME] knob clockwise increases the volume; turning it counterclockwise decreases the volume.

*The volume level is from 0 (minimum) to 33 (maximum).

Switching the display

Press the [DISP] button to select the desired display.

The display changes each time you press the [DISP] button.

*The display status varies depending on the mode you selected. For more information, refer to chapters of the each operation mode.

Adjusting the bass

Turning the [BASS] knob clockwise emphasizes the bass; turning it counterclockwise attenuates the bass.

*Adjustment range: -8 to +8 dB

Adjusting the treble

Turning the [TREBLE] knob clockwise emphasizes the treble; turning it counterclockwise attenuates the treble.

*Adjustment range: -7 to +7 dB

Adjusting the fader

Turning the [FADE] knob clockwise emphasizes the sound from the front speakers; turning it counterclockwise emphasizes the sound from the rear speakers. The fader adjusts both the source unit RCA and speaker outputs.

*Adjustment range: F12 (full front) to R12 (full rear)

14 CM05