Common Operations
AUX function
.This system has rear RCA cables so you can listen to sounds and music from an external device connected to this unit.
Cellular telephone mute
This unit requires special wiring to mute the audio signal automatically when a cellular telephone rings.
*This function is not compatible with all cellular telephones. Contact your local authorized Clarion dealer for information on proper installation and compatibility.
Changing the adjustment setting
1.Press the [MENU] button to switch to the adjustment selection display.
2.Press the [!] or [T] button to select the adjustment item.
Each time you press the [!] or [T] button, the adjustment item changes as following order: "DIMMER" ~ "CLOCK" ~ "LOUD" ~ "NF
VOL" ~ 'IS~D D~SP'1 ""\~~ ,ITVlVTR" '\\IU~- "T\l
.1~~~lE.it\" <III\\I1\\'- "TV D~VER'l ,\\1\\1), "AUX SENSl ' ~
"CONTRAST" ~ "SCROLL" ~
3.Turn the [VOLUME] knob to adjust the selected setting.
*When "ENT" is blinking on the display, press the [ENT] button to adjust the setting value.
4.After. the adjustment is complete, press the [MENU] button to return to the previous mode.
Notes:
•The adjustment setting is canceled when not operating for more than 10 seconds (except Clock and Sirius 10 setting).
•When each mode is selected, the item shown in grey will be displayed.
Dimmer Control
You can set the dimmer control.
*The factory default setting is "OFF".
1.Press the [MENU] button to switch to the menu mode.
2.Press the [!] or [T] button to select "DIMMER".
3.Turn the [VOLUME] knob to select "ON" or "OFF".
4.Press the [MENU] button to return to the previous mode.
Setting the clock
1.Press the [MENU] button to switch to the menu mode.
2.Press the [!] or [T] button to select "CLOCK".
3.Press the [ENT] button.
4.Press the [!] or [T] button to select the hour or the minute.
5.Turn the [VOLUME] knob to set the correct time.
*The clock is displayed in
6.Press the [ENT] button to store the time into memory.
7.Press the [MENU] button to return to the previous mode.
Note:
•You cannot set the clock when it is displayed with only the ignition on. If you drain or remove the boars battery or take out this unit, the clock is reset. While setting the clock, if another button or operation is selected, the clock set mode is canceled.
Setting the loudness
*The factory default setting is "ON".
1.Press the [MENU] button to switch to the menu mode.
2.Press the [!] or [T] button to select "LOUD".
3.Turn the [VOLUME] knob to select "ON" or "OFF".
4.Press the [MENU] button to return to the previous mode.
CMD5 21
