Clarion CMD5 manual Power does not turn on No sound is produced

Power does not turn on.

(No sound is produced.)

No sound output when operating the unit with amplifiers.

Incorrect wiring.

Amplifier turn-on lead is shorted to ground or excessive current is required.

The microprocessor has malfunctioned due to noise, etc.

Replace with a fuse of the same amperage. If the fuse blows again, consult your store of purchase.

Consult your store of purchase.

Turn the unit off and check each wire for a possible short. If the amplifier turn-on lead shorts out, cover it with insulation such as tape.

Open the front panel
by pressing the	Reset
[OPEN] button. Press
	button
the reset button for
about 2 seconds with a
thin rod.
The settings will
remain in the ROM
even if you press the
reset button.

The speaker protection circuit is operating.

The settings in the ROM failure. ROM are not

stored properly.

Disc does not start. The unit is not turned on.

There is a disc other than a compact disc or foreign matter already in place.

MP3IWMA files are absent in a disc.

1.Check the speaker connection.

2.Turn down sound volume. Function can also be restored by turning the power off and on again.

3.If the sound is muted again, consult your store of purchase.

If the error persists, consult your store of purchase.

Turn the power on.

Press the [~] button to eject.

Write MP3IWMA files onto the disc properly.

Files are not recognized Use MP3IWMA files encoded properly. as an MP3IWMA file.

File system is not correct. Use 1809660 level 1,2 or JOLIET or Romeo file system.

Disc is dirty. Clean the disc with a soft cloth.

Disc is heavily scratched Replace with a disc with no scratches. or warped.

CM05 33