Operating range: 30˚ in all directions 
Signal transmitter 
playback may not be possible. If moisture |
forms on the disc, wipe it off with a soft cloth. |
If moisture forms on the optical parts of the |
player, do not use the player for about one |
hour. The condensation will disappear natu- |
rally allowing normal operation. |
in the event that trouble arises, never open |
the case, disassemble the unit, or lubricate |
the rotating parts. |
Handling
•New discs may have some roughness around the edges. If such discs are used, the player may not work or the sound may skip. Use a ball- point pen or the like to remove any roughness from the edge of the disc.
Ball-point pen
Roughness
•To remove a compact disc from its storage case, press down on the center of the case and lift the disc out, holding it carefully by the edges.
•Do not use commercially available CD protec- tion sheets or discs equipped with stabilizers, etc. These may damage the disc or cause breakdown of the internal mechanism.
Storage
Remote control unit
This equipment has been tested and found to comply with the limits for a Class B digital de- vice, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reason- able protection against harmful interference in a residential installation.
This equipment generates, uses, and can radi- ate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio com- munications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interfer- ence to radio or television reception, which can
CAUTION
USE OF CONTROLS, ADJUSTMENTS, OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN, MAY RE- SULT IN HAZARDOUS RADIATION EXPO- SURE.
THE COMPACT DISC PLAYER SHOULD NOT BE ADJUSTED OR REPAIRED BY ANYONE EXCEPT PROPERLY QUALIFIED SERVICE PERSONNEL.
CHANGES OR MODIFICATIONS NOT EX- PRESSLY APPROVED BY THE MANUFAC- TURER FOR COMPLIANCE COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.
•Never stick labels on the surface of the compact disc or mark the surface with a pencil or pen.
•Never play a compact disc with any cellophane tape or other glue on it or with peeling off marks. If you try to play such a compact disc, you may not be able to get it back out of the CD player or it may damage the CD player.
•Do not use compact discs that have large scratches, are misshapen, cracked, etc. Use of such discs may cause misoperation or damage.
•Do not expose compact discs to direct sunlight or any heat source.
•Do not expose compact discs to excess hu- midity or dust.
•Do not expose compact discs to direct heat from heaters.
Cleaning
•To remove fingermarks and dust, use a soft cloth and wipe in a straight line from the center of the compact disc to the circumference.
•Do not use any solvents, such as commercially available cleaners, anti-static spray or thinner to clean compact discs.
•After using special compact disc cleaner, let the compact disc dry off well before playing it.
be determined by turning the equipment off and on, the user is encouraged to consult the dealer or an experienced radio/TV technician for help.
INFORMATION FOR USERS:.
CHANGES OR MODIFICATIONS TO THIS PRODUCT NOT APPROVED BY THE MANU- FACTURER WILL VOID THE WARRANTY AND
Sloping Console
This unit uses sloping consoles to make large-screen displays possible.
1. Turn the remote control unit over, then slide the rear cover in the direction of the arrow.
2.Insert the AA (UM-3/1.5V) batteries that came with the remote control unit facing in the directions shown in the figure, then close
the rear cover.
Notes: | |
Using batteries improperly can cause them to explode. | |
Take note of the following points: | |
• When replacing batteries, replace both batteries with | |
new ones. | Rear side |
• Do not short-circuit, disassemble or heat batteries. | |
• Do not dispose of batteries into fire or flames. | |
AA (UM-3/1.5V) 
Batteries
Rear cover
MODEL
12V 
GROUND
AM 530-1710kHz/FM 87.9-107.9MHz
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.
OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS:
(1)THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND
(2)THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE TAHT MAY CAUSE UNDESIRED OPERATION.
THIS PRODUCTION COMPLIES WITH DHHS RULES 21 CFR
SUBCHAPTER J APPLICABLE AT DATE OF MANUFACTURE.
CLARION CO.,LTD.
50 KAMITODA,TODA-SHI,SAITAMA-KEN,JAPAN
051 722 877
MANUFACTURED:
| | | 286- | |
SERIAL No. | Clarion Co.,Ltd. |
PE- | | | MADE IN | |
Bottom View of Source Unit
Be careful not to get your fingers caught when opening and closing the SLOPING CONSOLE.
1.For safety’s sake, always close the SLOPING CONSOLE before leaving this unit unused for a prolonged period or switching OFF the igni- tion key.
If you switch OFF the ignition key with the SLOPING CONSOLE tilted, the SLOPING CONSOLE does not close.
2.Before the SLOPING CONSOLE closes, there may be a braking sound from the safety mechanism. This is normal.
with the power on for the unit, press ANGLE |
button 6 to close the SLOPING CONSOLE. |
4. After a CD is ejected, the SLOPING CON- |
SOLE automatically returns to the tilted or |
closed state. If there is any obstruction when |
the SLOPING CONSOLE tries to close, the |
safety mechanism is triggered and the SLOP- |
ING CONSOLE returns to the open state. If |
this happens, remove the obstruction, then |
press OPEN button 6 or ANGLE button 6. |
mark.
CAUTION