7. OPERATIONS
Basic Operations | Note: Be sure to read this chapter referring to the front diagrams of |
chapter “3. CONTROLS” on page 5 (unfold). |
English
CAUTION
Be sure to lower the volume before switch- ing off the unit power or the ignition key. The unit remembers its last volume setting. If you switch the power off with the volume up, when you switch the power back on, the sud- den loud volume may hurt your hearing and damage the unit.
Turning on/off the power
Note:
•Be careful about using this unit for a long time without running the engine. If you drain the car’s battery too far, you may not be able to start the engine and this can reduce the service life of the battery.
1.Press the [FNC] button.
2.The illumination and display on the unit light up. The unit automatically remembers its last operation mode and will automatically switch to display that mode.
3.Press and hold the [FNC] button for 1 second or longer to turn off the power for the unit.
Note:
•System check
The first time this unit is turned on after the wire connections are completed, it must be checked what equipment is connected. When the power is turned on, “SYSTEM CHCK” and “Push Power” appear in the display alternately, so press the [FNC] button. The system check starts within the unit. When the system check is complete, the power is turned off, so press the [FNC] button again.
Selecting a mode
1.Press the [FNC] button to change the opera- tion mode.
2.Each time you press the [FNC] button, the operation mode changes in the following or- der:
Radio mode ➜ DAB mode ➜ SIRIUS mode
➜ CD mode ➜ DVD DECK mode ➜ CD changer mode ➜ MD changer mode ➜ DVD changer mode ➜ TV mode ➜ AUX mode ➜ Radio mode...
∗External equipment not connected with CeNET is not displayed.
Adjusting the volume
Turning the [ROTARY] knob clockwise increases the volume; turning it counterclockwise de- creases the volume.
∗The volume level is from 0 (minimum) to 33 (maxi- mum).
Switching the display
Press the [DISP] button to select the desired display.
Each time you press the [DISP] button, the dis- play switches.
∗Once selected, the preferred display becomes the display default. When a function adjust- ment such as volume is made, the screen will momentarily switch to that function’s display, then revert back to the preferred display sev- eral seconds after the adjustment.
∗When you have entered a title in a CD/MD, it
appears in the main display. If you have not entered a title, “D
Setting the clock
1.Press and hold the [TITLE] button for 1 sec- ond or longer to enter ADJ mode.
2.Press the [a] or [d] button to select the “CLOCK”.
3.Press the [
] button.
4.Press the [a] or [d] button to select the hour or the minute.
5.Turn the [ROTARY] knob clockwise or coun- terclockwise to adjust the correct time.
∗ The clock displayed in
6.Press the [
] button to store the time into memory.
7.Press the [TITLE] button to return to the previous mode.
Note:
•You cannot set the clock when it is displayed with only the ignition on. If you drain or remove the car's battery or take out this unit, the clock is re- set. While setting the clock, if another button or operation is selected, the clock set mode is can- celed.
DXZ935 13
