Battery Information 1-Way, Remote control housing | Clifford 570.4X

Battery Information (1-Way)

The 1way companion remote is powered by one 3V coin cell lithium battery (PN CR-2032) that will last approximately one year under normal use.

Battery Replacement
1	Side View	2	Rear View	1. Using a small ﬂat narrow object,
1		2		push latch down towards battery
				push latch down towards battery
				tray while gently prying the tray
				outwards from both ends until re-
				leased. Remove the tray from the
	Latch			remote control housing.
	Battery			+
	Tray			2. While observing the correct
				polarity, replace the old battery
				with a new one. Seat battery ﬂush

into tray and slide back into housing until securely latched. The remote control is now ready for use.

46	© 2011 Directed Electronics. All rights reserved.

Image 49

Clifford 570.4X manual Battery Information 1-Way, Tray while gently prying the tray, Remote control housing

Contents

Page Congratulations What you get Your Warranty Replacement remote controls Government Regulations and Safety informationImportant information Contents Page Page Getting Started Charging the remote control Can be located through the table of contents Keys to using this manualAt a Glance Function button Responder LC 2-Way At a Control Center Table below describes all the status screen icons Status Screen Icons Remote Start Zone Status Feature menus Commands and Conﬁrmations Using your SystemPerforming Commands Fault Condition Alerts Responder LC Command table Directed Electronics. All rights reserved Arm Basic Commands Direct AccessDisarm Remote Start AUX/Trunk Silent Arm Advanced Commands LevelSilent Disarm Press and release the button 1 time If set to display runtime Commands Runtime ResetTemp Request Press and hold the button Remote Valet Sensor BypassPress and release the button 2 times ﬁrm and the Remote start status icons update Commands Timer StartRuntime Remaining Car ﬁnder Sensor Silent ArmPress and release the button 3 times Smart Start Alarm Report Defogger Full Silent ArmPress and release the button 4 times Responder LC Conﬁguration Access menu itemsNavigating menus and options Button operation Main Menu Setup Remote menu Keypad LockMode Button followed by Remote Start Info Alert Car Runtime AlertScreen Color Temp Unit Button Beep Sensor AdjustSystem Type Clock Set Menu Pair Remote Power Off Demo mode Normal Arm Protection Alarm FeaturesSensor Silent Arm protection Sensor Warn-away Messages Full Silent Arm ProtectionFull Trigger Messages Emergency Override Alarm Report when disarming Trigger Zone Fault Report Nuisance Prevention NPC Alarm Report when requested Pit Stop Mode Remote Start FeaturesKey Takeover Disabling Remote Start Remote Start Safe-lockAdvanced Start Timer Start operation Temperature ReportingSmart Start operation Remote Start Time-out Alert Manual Transmission Start MTS modeStart the engine and the text and tones play as an alert Turbo Timer Mode Remote Start Error Passive Arming Remote and System OperationsAuto Re-arming Onetime Bypass Power Save Valet ModeAutomatic Remote Updates Rapid Resume Out of Range Feature not AvailableNo Remote Output Way Way Companion Remote Control Accessing Commands Using the 1 way companion remoteButton Auto Lock Car Select Programming Remote Features menu Remote control housing Battery Information 1-WayPolarity, replace the old battery Tray while gently prying the tray System Expansion Options Auxiliary Channels Driver door priority unlocking Low Battery Battery Information Responder LC Battery Life Battery Disposal Document Terminology Control Module Glossary of Terms Patent Information Government Regulations Remote Controls Control Center Safety Remote Start Capable InstallationManual Transmission Vehicles Operation of the Remote Start Module if the Vehicle Starts Interference Upgrades and BatteriesWater/Heat Resistance Limited lifetime consumer warranty Directed Electronics. All rights reserved