Out of Range
Each time a command is performed the remote will expect a com- mand confirmation from the system. If a command confirmation is not received the 
) and a fault tone will play as an alert.
No Remote Output
Occasionally when a command is performed the remote may not generate a command confirmation output or Out of Range output. This indicates that the system received the command but it was an incomplete command (e.g. Aux button pressed too short to activate the trunk release) or it was an illegal message (e.g. the command was corrupted due to local RF interference). These are temporary nor- mal functions of the system and remote, perform the command again within 10 seconds to return to normal operation.
Feature not Available
The 
message is a generic one which varies in cause and solution depending upon the command used:
Command | Cause | Reason/Solution |
Runtime Reset | Remote Start is Off | Only available when Remote Start is On |
Sensor Bypass | System is not armed | Only available when system is armed |
Defroster | Remote Start is Off. | Only available when Remote Start is On. |
| Not configured for | Only available when configured for |
| this. | Defroster control. |
42 | © 2011 Directed Electronics. All rights reserved. |
