![](/images/new-backgrounds/1313464/31346461x1.webp)
Pair Remote:
Remote Pair is a process where the Responder LC and the system in the vehicle learn each others encrypted identification, securing their communication from intruders. Please note that your remote controls come
Prepare the vehicle system to be Paired with a new remote
1.Open at least one of the vehicle’s doors.
2.Turn the key to the On position.
3.Within 5 seconds press and release 1 time the Control button on the Control Center.
4.Within 5 seconds, press and hold the Control button. The status LED will flash one time and the siren will chirp once to confirm the system is ready for remote pairing.
5.Release the Control button and proceed below.
Note: If pairing does not result within 60 seconds, the system will exit and the siren will chirp.
Prepare the new remote to be Paired with the system
1.Make sure the remote control is set for the desired Car 1 or Car 2 operation.
2.Perform the steps under Access menu items section to access the Pair Remote mode.
3.When the remote beeps 3 times and PAIR is displayed the remote is ready to pair.
4. Press and | hold the |
|
|
|
| button, the siren will chirp once and | |||
|
|
| |||||||
the remote will emit several tones to confirm successful pair- | |||||||||
ing. |
| is displayed and the remote returns to the main | |||||||
SUCCESS | |||||||||
menu. |
|
|
|
|
|
|
| ||
Note: |
| will be displayed and the remote will stay in the pair | |||||||
FAILED |
mode in case of an unsuccessful pairing. Check the system status and try again.
28 | © 2011 Directed Electronics. All rights reserved. |