Remote Control Networking Features
This section includes instructions for installing the
Installing the Network Controller Card
Perform the physical installation of the
Ethernet Setup
Use the following procedure to set up the Ethernet connection for the
1.On the
2.Power up the
3.Set the IP Address of your PC to 192.168.1.x, where x is a value other than 1. Consult your IT Department for details.
4.Point your Web browser to 192.168.1.1, the IP Address of the
5.Set the following parameters as required:
•Frame Name – This name identifies the frame.
•DHCP – Set this parameter to Yes if the frame IP Address is to be set automatically.
•IP Address – This is the IP Address, which is supplied by your IT Department, of the card.
•NetMask – This is the subnet mask for your LAN as supplied by your IT Department.
•Gateway – This is the IP Address for connection outside the subnet.
•Time Server – This is the IP Address of the NTP server used as a time source.
•Save Changes – Select this button to send your changes to the
6.Power down the
7.On the
8.Power up the
9.Verify the configured IP Address of the
This completes the procedure to configure the network settings for the
Functions of the Network Controller Card
The
Page 30 of 40 | 8310 User Manual • (V 1.0.1) |
