Coda Cold-Mount Laminator operation manual Heavy Duty Roll Feed Assembly

Heavy Duty Roll Feed Assembly

The Cold-Mount® Laminator should be on a sturdy level table top before attaching the Roll Feed Brackets.

To attach the Heavy Duty Roll Feed to the Laminator:

Place the brackets against the ends of the laminator base. The left bracket mounts against the left side of the machine and the right bracket mounts against the right side of the machine. Each bracket has a white label on it which identifies it as right or left.

Figure 29

The brackets should be positioned so the labels are against the ends of the laminator base. There is a fillister head screw on the label side of each bracket. Position the bracket so this screw head is butted against the output side of the machine base. This will “index” the brackets to the machine to help assure that the feed bar will be parallel to the rollers of the machine.

Figure 30

The threaded rod should be positioned so it goes through the hole drilled in one bracket base, all the way across the machine under the machine base and through the hole in the other bracket. Use a wrench to tighten the nuts on each end to clamp the brackets against the base

	Figure 31
Coda, Inc. • 30 Industrial Avenue • Mahwah, NJ 07430 Phone: 201-825-7400 Fax: 201-825-8133
Email: sales@codamount.com	www.codamount.com
Cold-Mount ® is a registered trademark of Coda Inc.
Cold-Mount® Laminator Operation Manual	January 2006