Adjusting the Rollers for Even Pressure

Using the gap adjusting knobs, lower the right side of the top roller so that it almost touches the bottom roller.

Then do the same on the left side.

Figure 7

Next make the fine adjustment on the right by turning the gap adjusting knob clockwise until the rollers just touch. Then do the same on the left side until the rollers are parallel.

Figure 8

Coda, Inc. • 30 Industrial Avenue • Mahwah, NJ 07430 Phone: 201-825-7400 Fax: 201-825-8133

Email: sales@codamount.com

www.codamount.com

Cold-Mount ® is a registered trademark of Coda Inc.

Cold-Mount® Laminator Operation Manual

January 2006

Page 7
Image 7
Coda Cold-Mount Laminator operation manual Adjusting the Rollers for Even Pressure