Basic Cold-Mount® Procedure (continued)
Use hand tension to wrap the print around the top roller. Make sure there are no gaps between the print and the roller.
Figure 16
Peel off the release liner. Run the print and the substrate through the laminator, taking care not to let the print flop down on the adhesive.
Figure 17
Always keep an even tight tension on the print to avoid any wrinkling. The print will come out perfectly mounted.
Figure 18
Coda, Inc. • 30 Industrial Avenue • Mahwah, NJ 07430 Phone:
Email: sales@codamount.com | www.codamount.com |
January 2006 | |
