Removal and Replacement Procedures
5.Make note of which wireless antenna cable is attached to which antenna clip on the Mini Card module before disconnecting the cables, then disconnect the cables 1 from the module.
6.Remove the two black Phillips PM2.0×5.0 screws 2 that secure the Mini Card module to the system board. (The edge of the module opposite the Mini Card socket rises away from the computer).
7.Remove the Mini Card module 3 by pulling the module away from the socket at an angle.
✎Mini Card modules are designed with a notch 4 to prevent incorrect installation into the Mini Card module socket.
Removing a Mini Card Module
Reverse the above procedure to install a Mini Card module.
Maintenance and Service Guide |
