Compatible Systems 2200R manual Smds Configuration

Set Dedicated connection Set SMDS connection

Use the Link Configuration: WAN Dialog Box.

30 Chapter 6 - Basic Configuration Guide

DECnet Protocol

Required for DECnet

WAN interfaces which are set for Frame Relay operation do not need any additional parameters set in order to function.

DECnet must be turned on globally, and turned on for a particular port, in order to be used.

WAN interfaces which are set for Frame Relay operation do not need any additional parameters set in order to function.

•Set DECnet on (globally, and for this port)

CV: Use the DECnet Routing Dialog Box (under Global/DECnet Routing) and the DECnet: WAN Dialog Box.

TB: Use configure and set the Mode keyword in the DECnet WAN 0 (and/or WAN 1) section.

Note: Setting DECnet on for any port with the command line also vsets DECnet on globally. In CompatiView you must set a global parameter and a port-specific parameter.

SMDS Configuration

This section covers the settings required for SMDS (Switched Multi-megabit Data Service) operation of the MicroRouter 2200R WAN 0 interface (IP only). SMDS is a connectionless, packet-switched service that offers LAN-to-LAN connectivity across a wide area at up to 1.544 Mbps.

Note: The IP protocol settings and the physical communication vsettings are the same as they would be for Frame Relay operation. The only parameters which should be set differently for SMDS are the Link Configuration and the SMDS addressing section.

Link Configuration

SMDS is presently supported in the MicroRouter 1250i1270i2250R2270R only via dedicated line operation.

•

•

CV:

TB: Use configure and then set the Mode and ConnectMode