Chapter3 - Network Installation 9
Chapter 3 - Network Installation
MicroRouter 2200R Back Panel
Thissection of the manual describes how to connect the MicroRouter
2200Rto your Ethernet network and your wide area communications
device(s). In summary, the steps for installation are:
1. Makesure the router is powered down and not plugged to any
powersource.
2. Connect the router to the Ethernet network.
3. Connectthe router’s secondary port to a wide area line communica-
tions device (if used).
4. Powerup the line communications device (if used).
Note: Youshould either wait to connect a synchronous line device
such as a CSU/DSU until after the interface has been configured as a
synchronousport, or power up the router before powering up the
CSU/DSU.(See Ch apter 6 - Basic Configuration Guide for more infor-
mation on configuring the router.)
5. Plugi n the power cable and power up the router.

Placing the Router

TheMicroRouter 2200R is meant to be left stand-alone on a desktop or
equipmenttable.
Note:When stacking other equipment on the MicroRouter 2200R,
donot exceed 25 pounds of evenly distributed weight on top of the
router. Additional weight may bend the case.