![](/images/new-backgrounds/1114148/11414815x1.webp)
3.0 Installation | EASICHECK™ |
| |
|
|
In common with all electronic equipment the panel should be installed in a clean, dry, reasonably well ventilated place, and not in direct sunlight. Temperatures in excess of 40°(C and below 5°(C may cause problems, if in doubt consult Cooper Lighting and Security Ltd. The panel should be located away from any potential hazard, in a position where it is readily accessible to authorised staff. Mount the panel to the wall using the drill template provided. Do not drill through the panel to the wall as dust will contaminate the circuitry, and prevent correct operation.
A metal back box is available for
When using 20mm conduit entry direct to the top of the housing, use a flanged coupler to ensure a wide distribution of pressure when tightening the coupling.
3.1 Installation Guide
Never Use oversized conductors or connect more conductors into termination points than it can safely contain.
Never Carry out insulation tests on cables connected to electronic equipment. Always Use the correct gauge of cables.
Always Adhere to volt drop limitation for loop cables
8