Cornelius 326142000 Filling Freeze Cylinders with Product, Setting ‘‘CLOCK’’ Time of DAY

NOTE: Syrup systems may be sanitized at this time as instructed.

FILLING FREEZE CYLINDERS WITH PRODUCT

1.Open product shutoff valves, located in lines leading from product blender tanks to freeze cylinders.

2.Press ‘‘AUTO BLEND 1’’ and ‘‘AUTO BLEND 2’’ switches to begin filling freeze cylinders. Open freeze cylinders faceplates relief valves to bleed air from cylinders while filling with product, then close valves. Do not relieve freeze cylinder pressure too fast or product will foam excessively in cylinder and lose carbonation.

ADJUSTING BEATER MOTOR CURRENT (EITHER SIDE)

1.Remove four screws securing upper control box cover, then remove cover for access to master circuit board inside control box.

2.Adjust beaters motors currents as instructed in SERVICE AND MAINTENANCE SECTION.

PROGRAMMING MAIN MENU SELECTIONS ONTO MESSAGE DISPLAY

The MAIN MENU SELECTIONS (see Table 4) may be brought up on message display as instructed in

SERVICE AND MAINTENANCE SECTION.

SETTING ‘‘CLOCK’’ (TIME OF DAY)

NOTE: ‘‘CLOCK’’ (TIME OF DAY) must be programmed into Unit before ‘‘DEFROST’’ (AUTOMATIC), ‘‘SLEEP’’ (SLEEP TIME), and ‘‘WAKE UP’’ (WAKE UP TIME) can be programmed into the Unit.

Program ‘‘CLOCK’’ (TIME OF DAY) into Unit as instructed in SERVICE AND MAINTENANCE SECTION.

PROGRAMMING ‘‘DEFROST’’ (AUTOMATIC) SETTINGS INTO UNIT

The automatic defrost system may be programmed into the Unit to occur up to nine different times during a day with a minimum of two hours between defrost time settings. Program automatic defrost time settings into the Unit as instructed in SERVICE AND MAINTENANCE SECTION.

PROGRAMMING ‘‘SLEEP’’ (SLEEP TIME) INTO UNIT

‘‘SLEEP’’ (SLEEP TIME) may be programmed into Unit to occur any time of the day after the Unit automatic defrost cycle has occurred. Unit will shut down (go into sleep time) and will not wake up (return to normal operation) until programmed ‘‘WAKE UP’’ (WAKE UP TIME) has occurred. Program ‘‘SLEEP’’ (SLEEP TIME) into Unit as instructed in SERVICE AND MAINTENANCE SECTION.

PROGRAMMING ‘‘WAKE UP’’ (WAKE UP) TIME INTO UNIT

‘‘WAKE UP’’ (WAKE UP TIME) May be programmed into Unit to occur any time of the day to wake Unit up (return to normal operation) after‘‘sleep time’’ has occurred. Program ‘‘WAKE UP’’ into Unit as instructed in

SERVICE AND MAINTENANCE SECTION.

PROGRAMMING POINT OF SALE MESSAGE DISPLAY

Three point of sale display messages are available to choose from and may be programmed into Unit by placing No. 1, No. 2, and No. 3 switches on DIP SWITCH assembly on master circuit board in appropriate positions. Program point of sale display messages into Unit as instructed in SERVICE AND MAINTENANCE SECTION.

326142000 14