Cornelius 620518916 NOTE Kit contains two plates, both mounting plates must be installed

Models: 620518916 620053922 620053923 629096853

1 9

Page 3

Icemaker & Adaptor Hold-Down Kit Installation Instructions

MUST Go Over the

Top of the Adapter

Lid as Shown.

Figure 4

5.Repeat Steps 1 through 4 for the opposite side of the dispenser.

6.Using the supplied silicone tube, seal icemaker all around to the adapter top, as shown in Figure 5.

Bead of Caulking

Around the Adapter

Top

Figure 5

7.Locate the icemaker mounting plates at the rear of the icemaker and position as shown in Figure 6, if plates are not already installed.

Figure 6

8.Using the plate as a template, drill 9/64 in. (0.140 in.) holes into the icemaker base and the dispenser, as shown in Figure 7.

- 3 -

Publication Number: 629096853INS

Image 3

Contents

ICEMAKER AND ADAPTER HOLD-DOWN KIT P/N The Parts shown in Table 2 are NOT Used for this InstallationParts Included in the Kit are Shown in Table Tools NeededLeft Side Straight Edge Goes to the Rear of the Dispenser Right Side Side Panel ScrewsNOTE Kit contains two plates, both mounting plates must be installed Flange on bracket MUST Go Over the Top of the Adapter Lid as ShownRun a Continuous Bead of Caulking Around the Adapter Top The Parts shown in Table 3 are NOT Used for this Installation INSTRUCTIONS FOR 30 INCH WIDE ICEMAKERS - FLAVOR FUSION UNITSDescription Insert Screws The Parts shown in Table 4 are NOT Used for this Installation INSTRUCTIONS FOR NON-30 INCH WIDE ICEMAKER - IDC SERIES UNITSDescription Description The Parts shown in Table 5 are NOT Used for this InstallationINSTRUCTIONS FOR 30 INCH WIDE ICEMAKER - IDC SERIES UNITS NOTE Kit contains two plates, both mounting plates must be installedIcemaker & Adaptor Hold-Down Kit Installation Instructions Publication Number 629096853INS Icemaker & Adaptor Hold-Down Kit Installation Instructions6. Repeat Steps 1 through 5 on the other side of the dispenser 2008, IMI Cornelius Inc