Cornelius 620053922, 629096853 The Parts shown in are NOT Used for this Installation, Description

Icemaker & Adaptor Hold-Down Kit Installation Instructions

Figure 12

7.Using the supplied sheetmetal screws, screw four (4) screws per plate into the dispenser wrapper and icemaker base.

8.Repeat Steps 2 through 7 on the other side of the dispenser.

INSTRUCTIONS FOR NON-30 INCH WIDE ICEMAKER – IDC SERIES UNITS

WARNING: Failure to follow the installation instructions correctly may result in equipment damage and/or personal injury.

The Parts shown in Table 4 are NOT Used for this Installation:

Table 4

Part No.	Description	Qty.
620518916	Adaptor/Icemaker Side Hold-Down Plate (Flat)	2

1.Locate the two right and left side hold down brackets, shown in Figure 2. These are the brackets with the bent flange on them.

2.Position bracket with the straight edge towards the rear of the unit, as shown in Figure 13. Also, the flange of the bracket must be over the adapter lid, as shown in Figure 4.

Straight Edge of Bracket Goes to the Rear of the Dispenser

Figure 13

3.Using the bracket as a template, drill two 9/64 in. (0.140 in.) holes in the dispenser wrapper.

CAUTION: Be careful not to drill too deep and/or too fast into the dispenser wrapper as damage may occur to unseen parts.

Publication Number: 629096853INS - 6 - © 2008, IMI Cornelius Inc.