Cornelius TP01070 manual Setting Water Flow Rate, Valve with Flow Adjusters

FlavorFusion® Training Manual

Setting Water Flow Rate

Setting the water flow rate will require a timed dispense. To accomplish this, the following procedure should be followed:

1.Enter programming mode for the valve block by simultaneously pressing and holding both programming buttons for 4 seconds (see FIGURE 3). The LED’s for

flavors 1-4 should flash off and then back on. The drink icon should turn off.

2.	Set the valve block to a 4 second pour
	mode by simultaneously pressing and
	holding Flavor 1 and Flavor 4 buttons until	Flow Adjuster Detail
	the flash pattern for all four buttons
		(Water)
	changes.
3.	Place an empty ratio cup under the
	appropriate nozzle and press the left
	program button for a 4 second dispense of
	carbonated water. There should be
	approximately 10 oz. dispensed.
4.	If necessary, adjust the water flow control

(see FIGURE 2), empty ratio cup, and	FIGURE 2. Valve with Flow Adjusters
	(see plumbing diagram for plumbing and valve
repeat step 3. Otherwise empty ratio cup
	configuration)
and repeat step 3 using the right program
button for plain water.

5.Exit 4 second pour mode by simultaneously pressing and holding Flavor 1 and Flavor 4 buttons until the flash pattern for all for buttons changes.

6.Exit programming mode by simultaneously pressing and holding both programming buttons for 4 seconds.

	Brand Flavor
	Programming
	Buttons
Bonus Flavor	(Left and
	Right)
Programming
Buttons
(Left
and Right)
Bonus Flavor Icon		Drink Icon
Bonus Flavor Button 1		Brand Flavor Button 1
Bonus Flavor Button 2
		Brand Flavor Button 2
Bonus Flavor Button 3		Brand Flavor Button 3
Bonus Flavor Button 4		Brand Flavor Button 4
Bonus Flavor Nozzle		Brand Flavor Nozzle

Publication Number: TP01070 - 4 - © 2004-2007, IMI Cornelius Inc.