Valve Removal | Cornelius TP01070 instruction

FlavorFusion®/FlavorOverload Training Manual

VALVE REMOVAL

1.Pull on retaining bracket (both sides) so the switch panel will rotate out of the way (see FIGURE 9).

Retaining

Bracket

FIGURE 8

FIGURE 9

2.Unscrew the switch panel (one on each side).

FIGURE 10

FIGURE 11

3.Place the tabs into the slot over the merchandiser lights.

FIGURE 12

FIGURE 13

4.Place the valve removal tool on the back block release latch, keep the handle flat.

Valve Removal Tool

FIGURE 14

© 2004-2007, IMI Cornelius Inc.

- 7 -

Publication Number: TP01070

Image 11

Cornelius TP01070 manual Valve Removal

Contents

Flavorfusion Flavoroverload FLAVORFUSION/FLAVOROVERLOAD Training Manual Table of Contents Publication Number TP01070 2004-2007, IMI Cornelius Inc Theory of Operation Product Overview Syrup brands psi min Syrup bonus psi max System Requirements Dispense Type 1, Carbonated water dispense Solid LED Programming Mode Flashing SequencesProgramming Valve with Flow Adjusters Setting Water Flow Rate Timed Dispense Procedure Adjusting Syrup/Water Ratio BrixSetting a Button to Dispense Non-carbonated Water Only Setting a Button to Dispense Carbonated Water Only Control Box Components DisassemblyMechanical Valve Removal Back Block Motor Removal Valve ServiceCarbonator Tank System Plumbing Diagram Flavor Fusion -16 Brand Plumbing Diagram Interface Board and Harness PIN-OUT Detail Interface Board Detail Fusion POINT-POINT Wiring Diagram Wiring Ladder Schematic 115V- Flavor Fusion Ladder Type Wiring Diagram PCB Troubleshooting Dispenser Troubleshooting Symptom Cause Remedy 2004-2007, IMI Cornelius Inc Publication Number TP01070 Publication Number TP01070 2004-2007, IMI Cornelius Inc Condition Diagnostics Guide for the Main Control Board see Figure IMI Cornelius Inc