Cornelius TP01070 manual Programming Mode Flashing Sequences

FlavorFusion®/FlavorOverload Training Manual

PROGRAMMING

NOTE: The programming mode is exactly the same for both brand and bonus keypads.

To enter the programming mode, press and hold the two program buttons (see FIGURE 3) at the top of the keypad for approximately 4 seconds. All keypad LEDs will flash off for approximately 1 second to indicate the start of the programming mode.

To exit programming mode, press and hold the two program buttons for approximately 4 seconds. All keypad LEDs will flash off for approximately 1 second, resuming normal operation mode.

Programming Mode Flashing Sequences

Once in programming mode, each dispense button LED flashes in a sequence cycle according to one (1) of six (6) dispense types. For Brand Keypads, only dispense types 1 and 2 should be used. For Bonus Flavor Keypads, dispense types 3 through 6 are used. The six (6) dispense types are described below, and shown in a timing diagram in FIGURE 1:

•Dispense Type 1, Carbonated water dispense: Solid LED

•Dispense Type 2, Non-carbonated dispense: Flashing LED 1.5 seconds ON, 1.5 seconds OFF

•Dispense Type 3, 1-second flavor shot: LED flashes once for ¼ second, followed by 3 seconds

OFF

•Dispense Type 4, 2-second flavor shot: LED flashes twice for ¼ second ON, ½ second OFF, followed by 3 seconds OFF

•Dispense Type 5, 3-second flavor shot: LED flashes three (3) times for ¼ second ON, ½ second OFF, followed by 3 seconds OFF

•Dispense Type 6, 4-second flavor shot: LED flashes four (4) times for ¼ second ON, ½ second OFF, followed by 3 seconds OFF

Start	Exit
proramming
	programming
mode	mode

1. Carbonated water dispense

2.Non-carbonated dispense

3.1-second flavor shot

4.2-second flavor shot

5.3-second flavor shot

6.4-second flavor shot

0 1 2 3 4 5

Time (seconds)

FIGURE 1

NOTE: It is possible to program a flavor shot into a keypad. It is also possible to program a cove dispense (type 1 or 2) into a flavor shot keypad. Both instances result in an incorrect operation and should be corrected.

© 2004-2007, IMI Cornelius Inc. - 3 - Publication Number: TP01070