Cornelius UF-1, UFB-1 manual Installation Checklist, Mounting Block Removal, Retrofitting

UF-1 and UFB-1 Valves Training Manual

3.Detach current valves:

–Remove front cover by lifting.

–Remove valve cover.

–Unplug wiring harness.

–Remove valve.

3.INSTALLATION CHECKLIST

1.Voltage and proper grounding.

2.Valve properly secured (latched) to block.

3.CO2 pressure to carbonator.

4.Water flow rate.

5.Syrup delivery pressure.

6.Finished product temperature less than 40°F.

7.Water to syrup ratio.

8.Portion size / top-off.

9.Water, syrup, CO2 leaks.

10.Cover secured to valve.

11.Valves flavor correctly marked.

4.RETROFITTING

UF-1 and UFB-1 valves will retrofit any valve with an identical mounting block screw pattern.

Note: Replacement of mounting block inlet fitting O-rings (part # 4073) is required when retrofit- ting valves.

4.1 Mounting Block Removal

To remove valve mounting block from the front panel, take out and save 4 screws.

IMPORTANT: Before installing block replace O-rings on each outlet fitting. Lubricate with Dow 111 or equivalent silicone lubricant. Do not use petroleum jelly.

© 1999-2005, IMI Cornelius, Inc. - 17 -

INSTALLATION