OPERATING INSTRUCTIONS
FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury, or loss of life.
A.The Bayvue DV has a pilot light system that must be lit by hand. Follow these instructions exactly, when lighting the pilot.
B.BEFORE LIGHTING the pilot light, it is important to smell all around the Bayvue DV for potential gas leaks. Be sure to smell next to the floor because some gas fuel is heavier than air and will settle to the lowest point.
WHAT TO DO IF YOU SMELL GAS
•Do not try to light the Bayvue DV.
•Do not touch any electrical switch; do not use any phone in your building.
•Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.
•If you cannot reach your gas supplier, call the fire department.
C.Use hand pressure to push in or turn the ON/PILOT/OFF control knob. Do not use a tool. If the control knob will not push in or turn by hand, do not attempt repair. Call a qualified service technician. Attempted repair may result in fire or explosion.
D.Do not use the Bayvue DV if any part has been under water. Immediately call a qualified service technician to inspect the Bayvue DV and replace any part of the control system and any gas control that has been under water.
LIGHTING INSTRUCTIONS
1. | STOP! Read the safety information above this section. | 8. | Push in and turn the ON/PILOT/OFF control |
|
|
| knob counterclockwise to “ON.” |
2. | Turn off all electrical power to the Bayvue DV. | 9. | Close the Bayvue DV bottom access panel. |
| Open the Bayvue DV bottom panel to expose the gas control panel. | 10. | Turn on electrical power to Bayvue DV. |
3. | Push in on the ON/PILOT/OFF control knob slightly and turn | 11. | The pilot flame should be visible through the |
| clockwise to “OFF.” |
| door glass in the lower right hand corner |
4. | Wait five minutes to clear out any gas. Then smell for gas including |
| between the front and middle logs. See the |
| near the floor. If you smell gas, STOP! Follow “B” of the safety |
| picture below for parts description and view |
5. | information above. |
| of normal pilot flame pattern. |
6.Turn ON/PILOT/OFF control knob counterclockwise to “PILOT.”
7.Push in the ON/PILOT/OFF control knob and hold in. By repeatedly pressing the piezoelectric igniter, a pilot flame should appear. If flame goes out repeat steps 5 thru 10. If flame stays lit, go to Step 10.
PILOT
ADJ
PILOT
ON
OFF
IH
O L
INOUT
TO TURN OFF GAS TO BAYVUE DV
1. | When servicing the Bayvue DV, turn off electrical power. | 3. | Push in ON/PILOT/OFF control knob and |
|
|
| turn clockwise to “OFF.” Do not force. |
2. | Open the Bayvue DV bottom access panel to see control panel. | 4. | Close the Bayvue DV bottom access panel. |
FIRST FIRE
Reduce odor by ventilating the room the first few times the unit is operated. Burn the first two fires no more than 15- 20 minutes. Allow the Bayvue DV to completely cool between burns. Burn the third fire
Version 1.0h | 46 |