Replacing the Blade Clutch Springs
WARNING! Before performing any maintenance procedure, stop the engine and disconnect the spark plug wire.
Tools Needed:
1/2"
Remove the belt guard by unscrewing the knob, pull the guard forward and lift to remove it. (See Figure 11 on page 19)
Return Spring
Eyebolt
Clutch Tab
Return
Spring
Clutch Spring
1.Remove one end of the return spring from the eyebolt on the machine
frame. (Figure 22) | Figure 22 |
2.Push the clutch tab toward the rear (clockwise) and unhook the clutch spring.
3.Unhook the return Figure 23
| spring | from the | clutch | Top Nut Removed | |||
| spring | beneath | the | Clutch |
| ||
| clutch tab. (Figure 23) | Spring | Tension | ||||
4. | Install | the | new | return | |||
| |||||||
| Spring | ||||||
| spring | by | reversing the |
| |||
|
| Unhooked | |||||
| above procedure. |
|
| ||||
|
|
|
| ||||
Clutch Spring |
|
| Pivot Bolt | ||||
1. | Remove | the | return |
| |||
| spring as above. |
| Clutch | Retaining | |||
2. Remove the top nut | Cam | ||||||
| from | the | clutch | cam |
| Nut |
pivot bolt. (Figure 24)
3.With a gloved hand, remove the idler tension
spring from the | pivot | Figure 24 |
bolt by pulling | the | spring toward the bolt and lifting it off (Figure 24). |
25 | DR SCOUT FIELD and BRUSH MOWER Safety & Operating Instructions |