Check before using your product
Please keep in mind!
Connect the power.
Plug the power cord into the electrical outlet. The bidet only works normally when the electricity is connected.
This product is for 120 V~ / 60 Hz only.
Make sure to connect the power plug to a grounded electrical outlet
Tips (120 V~ / 60 Hz) dedicated to the product.
Open the main water supply valve.
The bidet only works normally when water is supplied.
Check whether the product is in eco mode before using it.
- If the seat sensor does not detect anyone sitting down or no panel or remote control button is pressed for approximately 10 minutes, bidet eco mode is activated, the eco mode indicator is turned on, and the seat temperature is set to ‘L’ to reduce the power consumption of the product.
-When sitting down on the seat or pressing a panel button, the power indicator is turned on, the eco
mode indicator is turned off and the seat temperature returns to the last configured temperature. - Even if you sit down on the seat or press a panel button, the power indicator is not turned
on. This means that the power is turned off. In this case, press the power selection button to turn the power on before using it.
After the installation
Check if water leaks from the main water supply valve or the connecting hose. You must insert the rubber packing between the
Cleaning the filter on a regular basis
Clean the MESH filter on a regular basis (The cleaning interval may differ depending on the water quility). If the MESH filter is contaminated by foreign substances, the filter is blocked or
If the bidet has not been used for a long time
When the bidet has not been used for a long time, clean the filter and clean each part of the bidet such as the air dryer outlet, the nozzle and the seat before use (see p.16).
Configure and use a special mode according to your preferences.
You can configure one of the special modes (eco mode, seat sensor lock mode, silent mode) according to your preferences (see p.11).
Tips
Remove the protective film from the operation part before using it.
10
