Coway BA13-AE, BA13-BE, BA13-BR, BA13-AR manual Using the front nozzle

Using your bidet

Using the front nozzle

Using the front nozzle

1.Sit down on the seat and press the ‘Front Cleansing’ button on the operation part.

2.Self-cleaning for the front cleansing nozzle is performed, removing the cold water remaining inside the nozzle before the water stream is ejected so that the water can be set to a desired temperature for cleansing.

Tips The cleansing water ejection time may be delayed while the above functions are performed.

3.The cleansing water is ejected for approximately 1 minute and then stops automatically.

4.Self-cleaning for rear cleansing nozzle is performed for approximately 5 seconds after front cleansing. Then the nozzle retracts itself.

5.You can adjust the nozzle position by pressing the ‘Nozzle Position’ button.

6.You can adjust the water ejection angle by pressing the ‘Wide’ button (for the BA13-BR/BE only).

	If the ‘Front Cleansing’ button is pressed again during the cleansing operation, the front
Tips	cleansing function operates for another 1 minute.
	While cleansing, users can adjust the water temperature, water pressure, and nozzle
	position according to their preferences.
	You can not increase the water pressure level higher than level 2 if your area is in the
	following conditions.

-Main water supply temperature under 10 ℃ and rated power source under 110 V~ .

If the seat sensor does not detect a human body, the bidet will not work.

Moving

Press the ‘Move’ button on the operation part.

-The nozzle moves back and forth, providing a wider range of cleansing.

This will operate for as long as the front cleansing function continues.

You can control the nozzle position by pressing the ‘Nozzle Position’ button.

To stop the move function, press the ‘Move’ button once again.

Drying

Press the ‘Dry’ button on the operation part.

- Warm air is emitted for approximately 2 minutes.

If you wipe off the water lightly before turning on the air dryer, drying will finish faster.

You can control the air temperature by pressing the ‘Dry Temp.’ button.

If you press the ‘Dry’ button again during the operation, additional drying starts for another 2 minutes. If you press the ‘Dry’ button while cleansing, cleansing is stopped and drying starts immediately.

Stopping

To stop the current operation, press the ‘Stop’ button. - This stops all currently operating functions.

The drying function stops 2 seconds after the ‘Stop’ button is pressed.

16