1.Adjusttheblade(1)tothedesiredangle,andtighten
thebladebevellockknob.
2.Tightenmiterlockhandle(2)at 90°.
3.Hold workpiece firmly against the face of the miter
gauge throughout the cutting operation.
Fig, DD
COMPOUND MITER CROSSCUTTING (FIG. EL)
This sawing operation is combining a miter angle with a bevel angle.
MiTERiNG
1.Set the blade (1) to 0° bevel angle and tighten the blade bevel lock knob.
2.Set the miter gauge (3) at the desired miter angle and lock in position by tightening the miter gauge locking handle.
3.Hold the workpiece (2) firmly against the face of the miter gauge throughout the cutting operation.
Fig. FF
[4 WARNING
Always work to the right side of the blade during
this type of cut. The miter gauge must be in the right side groove because the bevel angle may cause the blade guard to interfere with the cut if used on the left side groove.
1.Set the miter gauge (3) to the desired angle.
2.Place the miter gauge in the right side groove of the table.
3.Set the blade (1) bevel to the desired bevel angle and tighten the blade bevel lock knob.
4.Hold workpiece firmly against the face of the miter gauge throughout the cutting operation.
Fig. EE
I3
14 WARNINe!
ABRASIVE AND METAL CUTTING BLADES MUST NOT BE USED WiTH THiS SAW
This saw was not made to cut metals or masonry materials. Doing so may result in injury, tt will also void the warranty.
USING WOOD FACING ON THE RiP FENCE (FIG. GG)
When performing some special cutting operations, you can add a wood facing (1) to either side of the rip fence (2).
NOTE: Before using wood facing on the rip fence, make sure the auxiliary fences are lowered flush to the table top.
1.Use a smooth straight 3/4 in. thick wood board (1) that is as long as the rip fence.
2.Attach the wood facing to the fence with wood screws (3) through the hole in the fence. A wood fence should be used when ripping material such as thin paneling to prevent the material from catching between the bottom of the fence and the table.
3
Fig. GG
2
1
2O
