DADOCUTS(FIG. HH)
•Only Stackable dado blades can be used on this
saw.
•DO NOT use Adjustable or Wobble type dadoes.
•Maximum dado cut width is Y2in.
1.A dado table insert must be purchased separately for this saw to accept a dado blade. Remove saw blade and blade guard for dado cuts ONLY. Reinstall and realign blade guard for all
2.Install the dado table insert making sure the rear of the insert is flush with the table. A rubber adjusting spacer is provided under the rear of the insert for this purpose.
3.Instruction for operating the dado is packed with the separately purchased dado set.
4.The arbor (1) on this saw restricts the maximum width of the cut to Y2in.
5.tt is not necessary to install the outside flange (2) before threading on the arbor nut (3) for maximum
Y2in. dado cuts. Make sure that the arbor nut (3) is tight, and that at least one thread of the arbor sticks out past the nut.
6.Use only the correct number of round outside blades and inside chippers as shown in the dado set's instruction manual. Blade/chippers must not exceed F2in. total in width.
7.Check saw to ensure that the dado will not strike the housing, insert, or motor when in operation.
[_ WARNING
For your own safety, always replace the blade, blade guard assembly, and doda insert when you are finished with the dado operation. You must also realign the blade guard assembly.
Fig. HH
1 |
I111
