INSTALLATION STEP 8
Fasten the Door Bracket
Follow instructions which apply to your door type as illustrated below or on the following page.
Ahorizontal reinforcementbrace shouldbe long enoughto be securedto two or three vertical supports,A vertical reinforcementbrace shouldcover the height of the top panel,
Figure 1 shows one piece of angle iron as the horizontal brace. For the vertical brace, 2 pieces of angle iron are used to create a U-shapedsupport. The best solution is to check with your garage
door manufacturer for an opener installation door reinforcement kit.
NOTE:Many door reinforcement kits provide for direct attachment of the clevis pin and door arm. In this caseyou will not need the door bracket, proceed to Step 9.
SECTIONALDOORS
1. | Centerthe door bracket on the previously marked vertical |
| centerline used for the header bracket installation. Note correct |
| UP placement, as stamped inside the bracket. |
2. | Position the top edge of the bracket |
| top edge of the door, OR directly below any structural support |
Fiberglass,aluminum or lightweight steel garagedoors WILL REQUIREreinforcement BEFOREinstallation of door bracket.
Contactyour door manufacturer for reinforcement kit.
Door
Bracket
Location
| HORIZONTALAND VERTICAL | |
| REINFORCEMENTiS NEEDEDFOR | |
Vertical | LiGHTWEiGHTGARAGE DOORS | |
(FIBERGLASS, ALUMINUM, STEEL, | ||
Centerline | ||
of Garage | DOORS WiTH GLASSPANEL, ETC.). | |
Door | (NOT PROVIDED) |
across the top of the door. |
3. Mark, drill holes and install as follows, depending on your |
door'sconstruction: |
Metal or light weightdoors using a vertical angle iron brace between the doorpanel supportand the door bracket:
•Drill 3/16" fastening holes. Securethe door bracket using the two
•Alternately, use two 5/16" bolts, lock washers and nuts (not provided) (Figure 2B).
Metal, insulated or light weight factoryreinforced doors:
•Drill 3/16" fastening holes. Securethe door bracket using the
WoodDoors:
•Usetop and bottom or side to side door bracket holes. Drill 5/16" holes through the door and secure bracket with 5/16"x2" carriage bolts, lock washers and nuts (not provided) (Figure 4).
NOTE: The
HARDWARE
SHOWN ACTUAL
SIZE
Figure 1
Vertical Reinforcement
Vertical Centerline
of Garage Door
/
Door Bracket
Screw
Figure2A
Vertical
Centerline
Door
Vertical Reinforcement
Vertical
Centerline
of GarageDoor
/
Bolt
Door
Bracket
Lock Washer 5/16" ,'/'_"
Nut
I Figure2B
Bolt 5/16"-18x2"
(NotProvided) Inside Edge of Door or Reinforcement Board
Vertical
Centerline
of Garage
Door
Figure4
._" Screw
Figure3
18