OPERATION
IMPORTANTSAFETYINSTRUCTIONS
To reducethe risk of SEVEREINJURYor DEATH:
1.READAND FOLLOWALL WARNINGSAND INSTRUCTIONS.
2.ALWAYS keep remote controls out of reach of children. NEVERpermit children to operate or play with garage door control push buttons or remote controls.
3.ONLY activategarage door when it can be seen clearly, it is
properly adjusted, and there are no obstructions to door travel.
4.ALWAYS keepgarage door in sight until completely closed.
NO ONESHOULDCROSSTHE PATHOFTHE MOVINGDOOR.
5.NO ONESHOULDGOUNDERA STOPPED,PARTIALLY OPENEDDOOR.
6.If possible, use emergency release handleto disengage trolley ONLY when garagedoor is CLOSED.Weakor broken springs or unbalanced door could result in an open door falling rapidly and/or unexpectedly,causing SEVEREINJURY or DEATH.
7.NEVERuse emergency releasehandle unless garagedoorway is clear of persons and obstructions.
8.NEVERuse handle to pull garagedoor open or closed. If rope knot becomes untied, you could fall.
9.After ANY adjustments are made,the safety reversalsystem MUST betested.
10.Safety reversalsystem MUST betested every month. Garagedoor MUST reverseon contact with
11.ALWAYS KEEPGARAGEDOORPROPERLYBALANCED(see page 3). An improperly balanced door may NOT reverse when required and could result in SEVEREINJURY or
DEATH.
12.ALL repairs to cables, spring assembliesand other hardware, ALL of which are under EXTREMEtension, MUST
be made by a trained door systems technician.
13.To avoid SERIOUSPERSONALINJURYor DEATHfrom electrocution, disconnect ALL electric and battery power BEFOREperforming ANY service or maintenance.
14.This operator system is equippedwith an unattended
operation feature. The door could move unexpectedly. NO ONESHOULDCROSSTHE PATHOFTHE MOVINGDOOR.
15.DONOTenablethe
16SAVETHESEINSTRUCTIONS.
Features
Your garagedoor opener is equippedwith features to provide you with greater control over your garagedoor operation.
TIMER-TO-CLOSE
The
ASSURELINKTM
AssureLinkTM technology uses a 900MHz signal to provide
REMOTECONTROLSAND DOORCONTROLS
Your garagedoor opener is compatible with up to 2 door controls. Your garagedoor opener has already been programmed at the factory to operatewith your remote control, which changes with each use, randomly accessing over 100 billion new codes. The garage door opener is compatible with up to 8 remote controls and 1 keyless entry.
THE PROTECTORSYSTEM® (SAFETYREVERSINGSENSORS)
When properly connected and aligned, the safety reversing sensors will detect an obstruction in the path of the infrared beam. If an obstruction breaks the infrared beamwhile the door is
closing, the door will stop and reverseto full open position, and the opener lights will flash 10 times. If the door is fully open, and the safety reversingsensors are not installed, or are misaligned,
the door will not close from a remote control. However,you can close the door if you hold the button on the door control or keyless entry until the door is fully closed. The safety reversing sensors do no effect the opening cycle.
ENERGYCONSERVATION
For energy efficiency the garagedoor opener will enter sleep mode when the door is fully closed. The sleep mode shuts the garage door opener down until activated. The sleep mode is
sequencedwith the garage door opener light bulb; as the light bulb turns off the sensor LEDswill turn off andwhenever the
garage door opener lights turn on the sensor LEDswill light. The garage door openerwill not go into the sleep mode until the garage door opener has completed 5 cycles upon power up.
LIGHTS
The garage door opener light bulbs will turn on when the opener is initially plugged in; power is restored after interruption, or when the garagedoor opener is activated. The lights will turn off automatically after
be used.
The garage door opener is equipped with an addedfeature; the lights will turn on when someone enters through the open garage door and the safety reversing sensor infrared beam is broken. For addedcontrol over the light bulbs on your garage door opener, see the Door Control section.
31