ASSEMBLY STEP 4
Install the Belt
1.Pull the belt around the idler pulley and toward the trolley. The ribbed side must contact the pufley.
2.Hookthe trolley connector into the retaining slot on the trolley as shown.
3.With the trolley against the screwdriver, dispensethe remainder of the belt along the rail length toward the motor
unit and around the sprocket. The sprocket teeth must engage the belt.
4.Checkto make sure the belt is not twisted. Connectthe trolley threaded shaft with the master link, as illustrated:
•Push pins of master link bar through holes in end of belt and trolley threaded shaft.
•Push master link cap over pins and past pin notches.
•Slide
To avoid possible SERIOUSINJURYto fingers from moving garagedoor opener:
•ALWAYS keep hand clear of sprocket while operating opener.
•Securely attach sprocket cover BEFOREoperating.
5.Insert the trolley threaded shaft through the hole in the trolley. Be sure the belt is not twisted.
Trolley Connector
BeltSprocket
Y
Threaded
Shaft
Slot
Trolley
Connector
Idler
Pulley
HARDWARESHOWN ACTUALSIZE
[©
Master Link
Master
Link Cap
| Notch |
Trolley | Master |
Threaded | Link Bar |
Shaft |
|
i i
Master Link
Trolley Threaded Shaft
10