Insta// TheProtectorSystem® (Continued)
MOUNTINGANDWIRING THE SAFETYREVERSINGSENSORS Figure 5
Mounting:
•Slide a
Carriage Bolt
• Finger tighten the wing nuts. |
|
OptionA | Figure 6 |
•Run the bell wire from both sensors to the garage door opener. Attach the wire to the wall and ceiling with the staples (Figure 6).
Option B - Pre-Wired /nsta//ation:
If your garagealready has wires installed for the safety reversing sensors, follow the instructions below:
• Cut the end of the safety sensor wire, making sure there is enough wire to reachthe
(Figure 7).
Figure7
Figure 8
•Separatethe safety sensor wires and strip 7/16 inch (11 mm) of insulation from each end. Choosetwo of the
Safety Reversing Sensor Wires
•Connect the
(Figure 9). | 7/16" |
CONNECTTO GARAGEDOOROPENER: |
|
| |
|
|
| |
• Strip 7/16 inch (11 ram) of insulation from each set of wires. |
|
|
|
Separatewhite and white/black wires sufficiently to connect to |
|
|
|
the opener | Figure 9 |
|
|
together. Insert wires into | Not Provided |
| |
|
| ||
|
|
| |
and white/black to grey (Figure 10). |
| Safety |
|
|
| Reversing | |
|
| Sensor | |
|
| Wires | Wires |
|
| White/Black |
|
Figure10 |
| Connect Wire to |
|
|
| ||
|
|
| |
Bell Wire | Finished |
|
|
Ceiling |
|
| |
m |
|
|
1. | Strip wire 7/16" (11 mm) | |
2. | Twist | like colored |
| wires | together |
3. | To insert or release | |
3afety Reversing |
|
|
Sensor | wire, push in tab with | |
screwdriver tip | ||
| ||
Invisible Light Beam | Red White Grey | |
Protection Area | ||
| ||
Safety Reversing |
| |
Sensor |
|
25