Chute /
Panel
IMPORTANT: This unit is shipped with engine oil, but
without gasoline, in the engine. After assembly, see
OPERATION section of this manual for fuel selection
and fill-up.
NOTE: To determine right and left hand sides ofyour
snow thrower, stand behind the unit with the engine
farthest away from you. See Figure I inset.
Your snow thrower has been completely assembled
at the factory, except the handle and the handle
panel, the discharge chute assembly, the chute crank
assembly and the shift rod. These parts are shipped
loose in the carton.
Removing From Carton
•Cut the corners of the carton and lay the sides
flat on the ground. Remove all packing inserts.
Remove all loose parts. For a complete list of
the loose parts, refer to the following section.
Move the snow thrower out of the carton.
•Make certain all parts and literature have been
removed before discarding the carton.
Loose Parts
(See Figure 1.)
a. Handle Panel and Chute Assembly
b. Right Hand Handle
Rear
Left
Rod
Figure I
c. Left Hand Handle
d. Two-piece Chute Crank Assembly
e. Shift Rod
f. Hardware Pack
Assembly Tips: For easier assemblypurposes,
removethe chute from the carton and lay it on topof
the engine. Do not unwrap the chute till you have
installed the handle panel and the clutchcables.
Tools Required
1. 1/2", 7/16", 3/8" wrenches or a set ofadjustable
wrenches
2. Set of standard head screw drivers
3. Set of philips head screw drivers
4. Funnel to fill up gasoline
AWARNING: Make certain the spark plug
wire is disconnected and moved away from
the spark plug before assembling the snow
thrower.
Attaching Handle Assembly
Stretch out control cables and place on the floor.
Place the right handle in position with the flat
side against the snow thrower. Youcan identify
the right handle by the traction drive control label
on it and the left handle by the auger clutch
control label on it.