GENERAL cent,
It isa known fact thatelectric tools are subject to accelerated wear andpossible
premature failure when they are used to workon fiber glass boats and sports cars,
wallboard, spackling compounds or plaster. The chipsand grlndings from these
materials are highlyabrasive toetectrica!tool parts,such as bearings, brushes,
commutators,etc_Consequently, it is notrecommended thatthis tool be used for
extended work on anyfiber glass material, wallboard, spackling compound, or plaster,.
Duringany use onthese materials, it is extremely important that the tool is cleaned
frequently by blowingwith an airjeL
/_ WARNING: ALWAYSwear safety goggles or safety glasses withside shields
orface shieldwhen blowing dust from tool when cleaning iLIf operation isdusty, also
wear a dust mask.
LUBRICATION
Al! of the beadngs in this toolare lubricated with a sufficient amount of high-grade
lubricantfor the life of the tool under normal operating conditions,.Therefore, no
further lubrication is required..
DOUBLE INSULATION
Double insulationis a concept in safety in electric power tools,which eliminates the
need for the standard 3-wire grounded power cord.All exposed metal parts are
isolated from the internal motor components with protectve insulation. Double
insulated tools do not need to be grounded_
IMPORTANT
The servicing of atool with double insulation requires extreme care and knowledge
ofthe system and should be performed only by a qualified service technician. For
service, we recommend that you return the tool to your nearest Sears Service Center
for repair. ALWAYS use original factory replacement parts when servicing..
EXTENSION CORDS
The use ofany extension cord will cause some loss of power.To keep the loss at a
minimum and to prevent overheating, use an extension cordthat is heavy enough to
carry the current thatthe tool will draw,
Awire gauge (AWG) ofat least t6 is recommended foran extension cord t00 feet or
_essin length. When working outdoorsALWAYS use an extension cord that is
suitablefor outdoor use, The cord's jacket will be marked WA.
E

!_CAUTION: Keep extension cords away from the cuttingarea, and position I

m
Ithe cord so it will not get caught on lumber, tools, etcoduring the cutting operation I
iiiil_U,,ll

_DANGER: Check extension cords before each use, If damaged, replace

itimmediately NEVER use a tool with a damaged cord because touching the
damaged area could cause electrical shock, resulting in serious injury.
Extension cords that are suitable for use with your saw are available at your nearest
Sears Store.
20
I!