ATTACHING REPLACEMENT BLADESTOTHE SAW cont, (SeeFigs. 16 -19)
7oPlace the pin (included with the wrench) intothe lined up holes_
8. Tighten the lock nut clockwise with the wrench and then remove the pin from the
blades (see Fig/19)_ This will allow the blades to turn freely,
9. Carefully turn blades with your hand to be sure they easily turn in opposite
directions,,
Fig. 16 Fig. 17
Flange
Fig, 18
GENERAL
I_WARNING: To avoid accidents, ALWAYS disconnect the tooi from the I
Ippwer sour_ BEFORE cleaning or performing any maintenance.
All parts represent an important part of the double insulation system and should be
serviced only ata Sears Service Center
Avoid using solventswhen deantng plastic parts_ Most plastics are susceptible to
damage from various types of commercial solvents and may be damaged by their use,
Use clean cloths to remove dirt.carbon dust, etc.
AwAR'i.G:oo.o_o,oo_,,m"e,o,_.o.o,...0o.o,,oo,_o_o,oon_o.o.pwoducts,penetrating oils, etcotocome in contact with plastic parts,,They contain
chemicals that can damage, weaken or destroy plastic,
19
I
I
I
I5-25-06