ASSEMBLINGTABLE EXTENSIONS
See Figure 10.
•Locate the tame extensions and the sma(I hard- ware bag with the following:
8 hex bolts
16 flat washers (5/16 in.)
,_ WARNING: The table extensions not only provide a support for large or wide pieces of
material, but help protect you. Serious injury can result from workpiece binding or kickback due to twisted rails or a misaligned rip fence.
•With the saw upside down, align table extensions to the saw table. Put a flat washer on each bolt, and attach the extensions to the table by inserting bolts through holes from the direction of the table.
•Slip the remaining flat washers and hex nuts on the bolts. Lightly tighten with a 12 mm wrench.
TABLE
EXTENSION
HEX
HEADBOLT
FLAT
WASHER
HEXNUT
Fig. 10
•Get help to stand saw assembly upright using the center saw table. Do not grasp saw by extensions.
,_, WARNING: Do not lift the saw table without
u
help. Hold it close to your body. Keep your knees bent and lift with your legs, not your back. Ignoring these precautions can result in back injury.
ALIGNING TABLE EXTENSIONS
See Figure 11.
A good alignment allows the rails to slide on easily.
•Stand at the front of the saw and line up the front edges of the saw table and extensions.
•Pull the extensions out slightly, put a block of wood where the extension meets the table, and tap the block of wood with a hammer. Check and repeat until the front edges are even.
•Lift each extension slightly until it is higher than table (if necessary, place a block below and tap upward). Center the block of wood over the front and rear edges and tap it until both are even (flush) with saw table. Recheck the front alignment. If even, tighten the screws with a 12 mm wrench.
BLOCKTABLE
OF WOOD EXTENSION
BLOCK
FRONT OFFRONT OF OF WOOD
SAW TABLE TABLE EXTENSION
|
|
| TAP |
|
|
| HERE |
| BLOCK | TAP | TOP OF TABLE |
TOP OF | OFWOOD | HERE | EXTENSION |
|
| ||
SAW TABLE |
| ! |
|
|
|
|
Fig. 11
SPLIT RAIL DESIGN
Your saw has a split rail design. The front and rear rails each have a left and right piece that must be installed. They are joined together on your saw with a connector. We suggest that you install the right rear and right front pieces first. Align and secure these pieces, then use the connectors provided to secure left rear and left front pieces.
rRRFTSMRN*TABLE SAW 315.228390 | 2O |
