Craftsman 315.22839 operatingposition INSTALLINGTHEREARRAIL, Rearrail, Connector, Hex Nut, Flat

Note:Therightsideof sawison yourrightwhen facingthesaw,asif youwerein normal

operatingposition.

INSTALLINGTHEREARRAIL

See Figures 12- 14.

,4_ WARNING: Front and rear rails must be installed and carefully aligned to reduce the risk

of kickback. Kickback can result in serious injury.

•From the carton, remove the rear rail pieces and the following hardware:

6 square head bolts (5/16-18 x 1 in.) 6 fiat washers (5/16 in.)

6 hex nuts (5/16-18) Rear rail connector

Right and left end caps for rear rail 2 screws (#8-32 x 1/2 in.)

Note: Remaining hardware from this hardware bag is used for installing the front rail and end caps.

•At the back of the table, put the square head bolts

in the holes in the edge of the saw table and the outer holes in each extension table so the bolt

heads extend outward 1/2 in.

•Under the table, loosely attach washers and hex nuts onto bolts. Slide the slot on the rear rail over

the bolts. Adjust each bolt to fit the rail closely to the table.

•Position right rail (longest piece) so that right hand edge extends 2-1/2 inches beyond table extension.

•Push right rail against table and tighten each nut with a 12 mm wrench, tf rail jams and does not slide easily over bolts, re-align table extensions.

•Put the end caps on rail ends. Insert the screws and tighten with a phillips head screwdriver.

TABLE

8LOTEXTEN810N

REAR RAIL

8QUARE

WA8HER

TABLE

REARRAIL

REARRAIL
CONNECTOR	Fig. 13

2-1/2 in,

ENDCAP

REARRAIL

8CREW

REAROF 8AW Fig. 14

8QUARE		HEX NUT
HEADBOLT8	FLAT
	WA8HER	Fig. 12

21 rRRFTSMRN°TABLE SAW315.228390