Craftsman 315.22839 owner manual Checking Squareness of Extension Tables to SAW Table, Sawtable

CHECKING SQUARENESS OF EXTENSION

TABLES TO SAW TABLE

See Figure 34.

The extension tables should be checked for squarness to the saw table for smooth operation of the rip fence and rails.

Place a square on the saw table, with the short end

up and check. The long end of the square should extend across one of the extension tables. If the

extension table is not square with the saw table, proceed as follows:

•Loosen the two hex nuts (one for each rail) securing the front and rear rails to the extension

table. Do not loosen hex nuts securing rails to saw table.

•Raise or lower extension table until it is square with the saw table.

•Tighten hex nuts securely.

•Check extension table on opposite side of blade. Repeat the above procedure if necessary.

		SQUARE
SAWTABLE		I
Io o
I o	o	o
EXTENSION		EXTENSION
TABLE		TABLE
		SQUARE
SAWTABLE
o o Io o	o	L
I	a
		o,/o
EXTENSION		EXTENSION
TABLE		TABLE
		Fig. 34

29 rRRFTgMRN°TABLE SAW315.228390