Craftsman 316.79197 Using the Craftsman Convertible TM Feature, Knob, To Install Attachments

attachment, read and understand the manual that

came with the attachment. Follow all safety

[_1 WARNING: Before you begin using any information contained within.

damage to the unit, shut the unit off before

!_l WARN'NG: To avoid serious personal injury and removing or installing add-ons.

USING THE CRAFTSMAN CONVERTIBLE TM FEATURE

You can convert this unit to edge	g0 ° Edging	Hole
grass.	(Trimmer	Onh

1.Make sure the unit is turned completely off.

2.Turn the knob counterclockwise to loosen coupler (Fig. 16).

3.Push in the release button (Fig. 17) and twist the shaft 90 ° until

the release button snaps into the Knob 90 ° hole (Fig. 16).

4.Turn the knob clockwise to lock

the coupler (Fig. 18). Fig. 16

Craftsman Convertible TM

CouplerPrimary Hole Release Button

Guide Recess

Fig. 17

Upper

Boom

Attachment

Knob

Fig. 18

CRAFTSMAN CONVERTIBLE TM FEATURE

CAUTION: These add-on attachments are to be I snapped into the primary hole only. Using the wrong hoe cou dead to persona n ury or damage to the un t.j

The coupler allows you to convert this unit for use with the following add-on attachments:

• Cultivator
Blade	Edger
Blower
Brush	Cutter
Pruner
To Install Attachments
	CAUTION:	Before operating	this unit, be sure	J
	that the release button is fully snapped into the
	primary hole (Fig. 16), and that the knob (Fig. 17) is
	securely tightened.

NOTE: To make installation easier, place the unit on the ground or on a workbench.

1.Make sure the unit is turned completely off.

2.Turn the knob counterclockwise to loosen the coupler (Fig. 16).

3.While firmly holding the attachment, push it straight into the coupler until the release button (Fig. 17) snaps into the primary hole (Fig. 17). The primary hole is on the opposite side of the coupler from the knob (Fig. 17). Align the release button with the Guide Recess (Fig. 17) to help installation.

4.Turn the knob clockwise to tighten.

To Remove Attachments

1.Make sure the unit is turned completely off

2.Turn the knob counterclockwise to loosen the coupler.

3.Press and hold the release button (Fig. 17).

4.While firmly holding the upper shaft boom (Fig. 18), pull the attachment out of the coupler.