Craftsman 536.886141 manual Fill OIL, Fill GAS, Before Starting the Engine

Models: 536.886141

1 63
Download 63 pages 63.53 Kb
Page 11
Image 11

°For ease of maneuverability in light snow conditions, disconnect the klick pin from the wheel locked position and push into the single wheel drive (klick pin through axle hole only) position (see figure below).

o Make sure that the klick pin is in the single wheel drive position of the axle only and not through the locked position.

Unlocked

Position

KlickPin

Single Wheel Drive

BEFORE STARTING THE ENGINE

FILL OIL

NOTE: Engine may already contain some

residual oil. Check frequently when filling the crankcase. Do not over fill. This snow

thrower was shipped with a 20 ounce con- tainer of 5W30 motor oil. This oil must be

added to the engine before operating. Re- move the oil fill cap/dipstick and fill the crank case to (FULL) line on dipstick (see next figure).

Tighten the fill cap/dipstick securely each time you check the oil level.

For extreme cold operating conditions of 0°F and below, use a partial synthetic 0W30 motor oil for easier starting.

NOTE: S.A.E. 5W30 motor oil may be used to make starting easier in areas where the temperature is 20 ° E or lower.

.._Oit Fill/Dipstick

• __ _IF NOTE: Oil level must be

_),_y between fu,I and add mark.

FILL GAS

NOTICE: ENGINES WHICH ARE CERTI- FIED TO COMPLY WITH CALIFORNIA AND US EPA EMISSION REGUL/_TIONS FOR ULGE ENGINES: Are certified to op- erate on regular unleaded gasoline. Include the following emission control system(s): EM, TWC (if so equipped). Include any user adjustable features - therefore no other ad- justments are needed.

WARNING: Experience indicates that alco- hol blended fuels (called gasohol or those using ethanol or methanol) can attract moisture which leads to separation and for- mation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage.

To avoid engine problems, the fuel system should be emptied before storage for 30

days or longer. Start the engine and let it run until the fuel lines and carburetor are

empty° Use the carburetor bowl drain to empty residual gasoline from the float chamber. Use fresh fuel next season (see Storage instructions on page 22 for addi- tional information).

Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

Fill the fuel tank with a fresh, clean, un- leaded regular, unleaded premium, or reformulated automotive gasoline only. DO NOT use leaded gasoline. Be sure that the container you pour the gasoline from is clean and free from rust or other foreign particles. Never use gasoline that may be

stale from long periods of storage in the container.

CAUTION: Gasoline is flammable and caution must be used when handling or stor- ing it.

Do not fill fuel tank while snow thrower is

running, when it is hot, or when snow thrower is in an enclosed area.

Keep away from open flame or an electrical

spark and DO NOT SMOKE while filling the fuel tank.

NEVER fill the tank completely. FILL THE TANK to within 1/4" - 1/2" from the top to provide space for expansion of fuel.

Always fill fuel tank outdoors and use a fun- nel or spout to prevent spilling°

11

Page 11
Image 11
Craftsman 536.886141 manual Fill OIL, Fill GAS, Before Starting the Engine